as a matter of fact I have, and it runs fine... are you sure it's not something you're doing wrong?  check your drivers and such, make sure they are up to date.  And you are using the dreamscenes from Vista Ultimate, or are you running Deskscapes?  There may be an update that addresses your specific problem, but believe me I've been running dreams since I upgraded to Vista and have had very few problems with them.

And no Wincustomize doesn't have shares in anything, it's a community run site, which means that it's run by us, the users. Wincustomize is a forum for skinners, and artists to post their work, anything more than that always goes back to that goal.  The reason you pay for a subscription, is to pay for the bandwidth the site uses, and so fourth.

i didnt say they didnt run ok, i said it was a cpu hog. i suggest you check your usage too.

yes my drivers are upto date. and i am running deskscapes

Different dream run differently based on many things including video length, resolution, etc.

Try a few dynamic dreams.

https://forums.wincustomize.com/posts/3190120

Don't let the door hit you in the ass........

Yea seriously....   you seem to be having a lot of problems lately supershaft1961.  And you don't seem to be taking it very well either.  This is really a lot of 'issues' to be falling on one person.   Cursed??

The amount of cpu usage depends on a number of factors.

Your cpu speed, the number of CPU cores you have, what type of graphics card you have, what type of dream it is.

WMV based dreams tend to use more cpu than MPG based dreams and the higher the resolution the dream is, the more cpu it tends to use.

Dynamic dreams such as all of those released by myself should use very low levels of cpu as they do not need to decode high resolution video which can be very cpu intensive.

ok, before any dream is applied.... CPU: 2%, Memory: 29%

Dream 1 --  CPU: 10%, Memory: 31%

Dream 2 --  CPU: 10%, Memory: 36%

Dream 3 --  CPU: 14%, Memory: 32%

Dream 4 --  CPU: 11%, Memory: 34%

Dream 5 --  CPU:  9%, Memory: 35%

Thats an ave. of a 8.8% increase in CPU and 4.6% in Memory

Hum...  I'm not seeing the hog anywhere 

<--- wait, found it 

OK ,

For all of you who have your dreams working at a low Rate. I applaud to you. That is fantastic news.

Now for us who have vista and see this spike and even see the BSoD like me. This problem does exist.

And yes. I have brought it up to Stardock  support. without any resolve.

could be my NVIDIA graphics driver or anything else.

We all have different setups driver and the rest of the stuff that makes a computer work.

If it works for you. Good, I am happy for you.

I will tell you that this problem does exist on my computer.

using dynamic Dreams use a lot less CPU but have given me the Blue screen of Death.

I will also add that the first version of descape worked like it should. all other updates after have not worked for me.

I will tell you all. I love Stardock and all programs they make.  I know sooner or later that this will be fixed by Stardock. I am just waiting for that time.

If you are not a fan of Stardock or things don't work right for you. you have a choice to not use them.

WeatherBound: Just out of curiosity.....what did the BSOD say?

You can not read it because its to blurry. Its kinda strange.

The screen goes blue with many shades of blue. you can tell it tries to display words but its a mixed in with shades of blue.

Then screen shuts down to black. so blue screen only stays for maybe 2 seconds then computer shuts down.

That points to an onboard chip headed south....which is to say your motherboard needs to be replaced. I do find it a bit strange that it only happens when you load Dreams........(if that's the case. heat might be the culprit)  

In Control Panel/ System/ Advanced System Settings/ Advanced/ Startup and Recovery - you do have 'Automatically Restart' un-checked, correct? While that would explain a reboot (not a heat related/hardware failure shutdown), under no circumstance, with viable hardware, would the blue screen distort.

It does not happen to every Dream i try. Sometimes they work for a couple of days then crashes. Some dreams work but with the high CPU usage.

I will say that it did do the same thing a while back when i tried to install ZoneAlarm.

I un-checked the auto restart.

You and me talked about a heat problem before.

I sent my computer to HP and they replaced the mother board and a whole lot of other stuff because i sent my notebook to them three times.  I told them i wanted it fixed.

They replaced it just to shut me up. Lol

I did extend the warrantee, do to are talks before.

To the most part. My computer works good until i load a dream. so i do blame the dreams since thats when i see the bsod.

I will contact HP support and see what they say about not able to read the bsod.

Considering the amount of 'security' software you've tried on this machine, let's explore a few things that could cause excessive heat and/or a BSOD:

Do a search for: vsdatant.sys

                        klif.sys

If you find either, go no further.

Start/ All Programs/ Accessories/ Command Prompt: right click, "Run as Administrator". Type SFC /scannnow

you know,

               apat from the odd serious commentor on these forums, the rest of you are a bunch of brainless morons with little dicks. grow up you sad berks you have nothing to say and you are saying it too loudly

Personal attacks are not acceptable. Please refrain from further comments such as these or your posting priviledges will be put on hold.

Yrag

Did the searches and found none of them.

I Did the SFC /scannnow

ban me anyway hankers. i dont give a shit.

and.....?

If nothing, run a looped video or a DVD movie and see if it blue screens.

I didn't even realize this was that guy....

and on your way out buy a computer with a better processor....

then why are you here?   I come on here to help people with real problems... and to get answers to mine, but I can't figure why you are here...