What is the normal CPU Temp?
Saturday, December 10, 2005 by Cyberworld | Discussion: WinCustomize Talk
I have P4 3.06GHZ overclocked to 3.3Ghx. My CPU temp shows 62-72 Celsius and System temp 30-40 Celsius. Is it ok or i need some kind of cooler?
What is your System and CPU temp readings? Just to be able to compare? Thnx for any help or info...
Reply #2 Saturday, December 10, 2005 11:38 AM
Reply #3 Saturday, December 10, 2005 11:43 AM
Reply #4 Saturday, December 10, 2005 12:09 PM
And it is whisper quiet.
w00t for BTX!

Reply #5 Saturday, December 10, 2005 12:26 PM
E.G.> Some noise comes from one of the hard disks...is it about to die on me? Time for back-up?
E.G.2> I can hear the CPU Fan from my bedroom, 10m away!!! Is it okay?
Reply #6 Saturday, December 10, 2005 3:19 PM
Just a suggestion...
Good luck!
Reply #7 Saturday, December 10, 2005 4:05 PM
Reply #8 Saturday, December 10, 2005 5:28 PM
| P4's run alot hotter than AMD chips!!! |
Another statement frequently heard but never backed up by fact:
My P4 2.66Mhz running at 21C - a lot cooler than any AMD chip could, even with fancy water cooling etc
Reply #9 Saturday, December 10, 2005 5:32 PM
Reply #10 Saturday, December 10, 2005 5:35 PM

Reply #11 Saturday, December 10, 2005 5:47 PM
| P4s are cooler |
correct
| 70-75C is normal for cpu. |
only if you running it in a bakery
| Some noise comes from one of the hard disks...is it about to die on me? I can hear the CPU Fan from my bedroom, 10m away!!! Is it okay? |
that's called paranoia
The first thing to remember is that MB and/or diode sensors are notoriously wrong and all any software monitoring does is repeat the mistake. While the bios reads the same thing it's more reliable then installed software, so check the bios figures to see if it is, in fact, the same as what your monitoring software is telling you. The standard gauge for excessive heat is that your computer will become unstable (or shutdown/reboot). It becomes unstable not because it thinks it's running hot....it's because it is running hot.
Facts:
Intel's run cooler then AMD
Intel's will throttle down when getting hot (AMD's will keep on trucking until shutoff or meltdown)
All Intel's and newer AMD's will shutdown at max temperature (70c-95c)
64x in either flavor runs cooler
The only reliable way to check if you think it's running hot is remove the side cover, ground yourself to the case and touch the side of the heatsink...if you say ouch..you have a problem.
If after checking the bios and doing the touch test, you are getting readings of 20c to 65c on either chip (idle or load) without any system instability, then it's time to worry about something else........
........like global warming.
Reply #12 Saturday, December 10, 2005 5:52 PM
| Current temps....Case 26C, CPU 27C |
.....that's 'cause you're coooooooolllllll

Reply #13 Saturday, December 10, 2005 5:56 PM
| My P4 2.66Mhz running at 21C |
......then you're coooollllllleeerrrrr then Jafo.....

Reply #14 Saturday, December 10, 2005 5:59 PM
What gives?Reply #15 Saturday, December 10, 2005 6:06 PM
| If after checking the bios and doing the touch test, you are getting readings of 20c to 65c on either chip (idle or load) without any system instability, then it's time to worry about something else........ ........like global warming. |
Thank you for the full info Yraq, i think this piece of advice applies to me as this situation has been going on for a year and a half now...
Well where can i find that Greenpeace site...hmmm....googling...got it...ah...global warming... 
Reply #16 Saturday, December 10, 2005 6:28 PM
I just found out why every sensor utility fails on my computer. Because Dell doesn't include them in their systems.
bugger. Speedfan gave me a temperature for my harddrives though. ..but, not really what I was looking for...Reply #17 Saturday, December 10, 2005 7:12 PM

Reply #18 Saturday, December 10, 2005 9:40 PM
Personally I installed a fan speed controller when I built my system, it has thermal sensors attached to everything in there ..MoBo, Heatsink, graphics card..etc..etc and it gives me a real time digital readout of all the temps within... I put 100% load on my processor a 100% of the time,24/7, thats the reason I installed the controller...So far, it has worked like a charm, but, LoL..I'll tell ya a secret in case you plan on getting something like it... if you set the fan speeds too high it can actually create more heat within the case, probably due to the fans running full time instead of just when their needed..I dunno..LoL... but it will take a bit of fine tuning once you get one up and running... That is if you decide it is really that much of a concern....Then there is the fancy water cooling stuff, I actually dont see a benefit to them other than the reduction of fan noise, and seriously, the fan noise doesnt bother me at all...
Anyway..just a couple "Cool" alternatives...
Reply #19 Sunday, December 11, 2005 1:40 AM
| (AMD's will keep on trucking until shutoff or meltdown) |
I'll vouche for you on this gary...I melted my old AthlonXP3000 at 195 degrees F, overclocked it to 2.8 ghz. I had it running stable at 2.67, but just had to push it. Was benching it and went to get a cup of coffee...
Cyber, you might do the touch test just to be sure...55 C is what..200+ F?
Reply #20 Sunday, December 11, 2005 1:42 AM
Please login to comment and/or vote for this skin.
Welcome Guest! Please take the time to register with us.
There are many great features available to you once you register, including:
- Richer content, access to many features that are disabled for guests like commenting on the forums and downloading skins.
- Access to a great community, with a massive database of many, many areas of interest.
- Access to contests & subscription offers like exclusive emails.
- It's simple, and FREE!








Reply #1 Saturday, December 10, 2005 10:38 AM
Your systemp is also normal.